• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by gyman98

  1. G

    Genie 1930 electrical issues

    Yes it’s been working flawlessly since
  2. G

    Genie 1930 electrical issues

    Perfect thanks again
  3. G

    Genie 1930 electrical issues

    I hope so. Any reason I can’t just replace the circuit board? Something like this ? https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F172602495812
  4. G

    Genie 1930 electrical issues

    Thanks for all your help. I really appreciate it! I get OL at the black and orange wires on the platform controller with the ecm unhooked. On the ecm I have 120ohm between c1 and B1
  5. G

    Genie 1930 electrical issues

    I’m very confused now. I have orange on C1 which seems to be correct. White on C2 which should be red. Black on B1 which should be blue. Blue on A2 which should be white.
  6. G

    Genie 1930 electrical issues

    I get 120ohm at the circuit board between the orange and blue wires but not at the harness where it plugs into the ecm. However my blue wire goes to A2 on the ecm harness and the orange to C1. If I test both those at the plug I get 120ohms On mine the black wire goes to B1
  7. G

    Genie 1930 electrical issues

    If I unplug the ecm and probe the wires I get OL, if I test the pins on the ecm I get 120ohms. Platform controller is NFG?
  8. G

    Genie 1930 electrical issues

    Thanks! Hopefully I understood this correctly. I probed the back of the wires and I get 120ohm. I disconnected the platform and still 120. I unplug the ecm and test the 2 pins and get 120
  9. G

    Genie 1930 electrical issues

    Ok so I found some wires on the platform to main harness plug, fixed those now I get a 01 and a 02 code on the platform control. I tested continuity from the platform control right down to the ecm and all 5 wires tested fine. Ecm shot?
  10. G

    Genie 1930 electrical issues

    Sparks fly when I do that, short to ground. I don’t have those option wires hooked up that disable the machine when charging but I’ll still try and isolate the charger
  11. G

    Genie 1930 electrical issues

    They go to the motor controller
  12. G

    Genie 1930 electrical issues

    I Agree that I don’t think it should be negative either, both little wires going to it are both ground as well according to my multimeter
  13. G

    Genie 1930 electrical issues

    Correction, the top is positive and the bottom is negative. I don’t see why the bottom would be negative?
  14. G

    Genie 1930 electrical issues

    I’m not sure what it is, my schematic doesn’t show it. I have nothing, no clicks, no lights
  15. G

    Genie 1930 electrical issues

    I do not have power going through this black box where the 2 positive cables attach. Top has 25volts and the bottom has 1.5volts
See more
Top