• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by djhutt

  1. D

    Doosan Light Tower....2 lights work 2 dont

    Lamp lead to 120 line. Lamp com to Neutral
  2. D

    Original Bobcat

  3. D

    Cat 3126 coolant hose how to disconect

    Shrink fit hose I cut it out and put a 3/8mip to 3/8 barb in the block and cut the other end off the surge tank got a piece of 3/8 hose and 2 spring clamps and done.
  4. D

    Cat 3126 coolant hose how to disconect

    I have a 1999 Sterling with a 3126 ser 7AS44238 there is a hose that goes from the engine next to the thermostat housing to the surge tank. I want to replace the hose, it has plastic fittings on the ends that I don't want to break when removing. is there a trick or special tool used to remove...
  5. D

    Ford L7000 with Ford v636 Diesel?

    I have one in a 88 c8000. Everyone hates them but it has been reliable for the 25 years I had it fires right off at -10F smokes a little when cold but I wouldn't hesitate getting another.
  6. D

    Chevy C60 OBD Connector?

    I had an 87 c60 and an 86 g30 that if I remember correctly had an orange 8 or 10 pin inline connector under the hood on the driverside fender that I jumped the end 2 terminals and it would flash codes with the check engine light
  7. D

    How to set a utility pole (attach choker chain etc)

    Choke it then a half hitch above the CG I lift many tapered flagpoles this way when set let loose and the chain will slide down
  8. D

    MT653 Allison Transmission problem

    Check the governor and the governor screen.
  9. D

    Any one familiar with Allison MT 653

    Governor screen all plugged up. Cleaned screen changed fluid and filters, all good now back to normal. Thank You
  10. D

    Any one familiar with Allison MT 653

    1990 ford C8000. I have the service manual. Going to check the modulator actuator tomorrow. the pin is tight on the modulator cable and the throttle linkages are tight and don't look to have moved (adjustments) recently.
  11. D

    Any one familiar with Allison MT 653

    I have a MT 653 behind a Cat 3208 with ~43k miles suddenly won't shift into 5th gear with full throttle. Can get into high gear with part throttle. Was driving in high gear full throttle flat ground and suddenly shifted to 4th over speeding engine. Fluid is Dex III full on dipstick and not...
  12. D

    Help I need a hero! 1980’s Massey 20c part identification

    It looks to be Massey 504042m1 and jacks small engines has it for $0.89. Parts book found here http://www.agcopartsbooks.com/PartsBooksN/Viewer/book.aspx?book=agco/651377
  13. D

    1969 Ford 391FT - modern day equivalent

    I have a 1990 C8000 with AC
  14. D

    2004 kenworth T300 ABS light

    Dip switches probably speedometer calibration
See more
Top