• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by darvi

  1. D

    2006 Bobcat 337G Aux Hydraulic Button on Control Panel not working

    Or maybe a selioned or coil that send signal to valve to work the hyd system
  2. D

    Cat 365 c ecm flashing and message oil pressures low

    Ok will check. 2maro. And if to high or to low could it be a oil pressure sensor bad?
  3. D

    2006 Bobcat 337G Aux Hydraulic Button on Control Panel not working

    Or try disconting battery for 10 min and test it out again
  4. D

    2006 Bobcat 337G Aux Hydraulic Button on Control Panel not working

    Did you test if you were getting power to what you were trying to use i seen u said u checked relay what about a fuse
  5. D

    Cat 365 c ecm flashing and message oil pressures low

    No i did not where is the port that I put gauge on what should pressure be at
  6. D

    Cat 365 c ecm flashing and message oil pressures low

    Anyone ever had that issue happen my boss is wanting to take machine back to shop to do a engine re build it runs good in the morning but when comes to getting hot everything stops working. Wont turn just looses complete power buzzer rings loud and screen pops up with em and oil pressure low
  7. D

    ta40 w allison T wont go fwd or reverse and bed wont go up

    truck acts like it wants to go fwd or rev and also bed trys to lift but wont go any ideas
See more
Top