• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by chris allen

  1. C

    Johndeer 5205. Rock shaft want lift

    Helping a neighbor out with a 5205 that has been sitting with hyd issues, finally getting around to trying to help him with it, did the basic normal stuff, drained the fluid an pulled out the strainer an it was clean, also changed out the spin on filter too. Also checked all the suction spots...
  2. C

    Johndeer 325a skid steer injection pump timeing

    Hey guys. Looking for some good way to reinstall the separate injector pumps on the power tech motor , serial is A137637. Well motor had been putting lil engine oil into the coolant, it was not the typical grey color after mixed, it was just spots of burnt motor oil threw out it. So I...
  3. C

    Bobcat 753 F series. All lites blinking on controller?

    Changed alternator out an been good since
  4. C

    Bobcat 753 F series. All lites blinking on controller?

    Tested the alternator today an it was putting out 18.5, idled it down an it like you said worked fine as long as I kept the voltage around 15 a lower areas. It looked like the controller was blinking a code , noticed it would flash differ patterns. Can ya give me some info on how to read the...
  5. C

    Bobcat 753 F series. All lites blinking on controller?

    Yes makes sense. I’ve heard of the chargeing issues off G series give fits with electrical parts of the machine. Thx for ur time and advice
  6. C

    Bobcat 753 F series. All lites blinking on controller?

    Hey guys, helping out a friend, been haveing trouble off an on with his bobcat, his 753 F series operates decent for its age, but have noticed that if left idled up an flip the lap bar up then flip it back down the brakes want unlock, an when I look down an the interlock controller under my...
  7. C

    D57s want steer

    Hey again guys, just now getting back to the loader, ran it today with gauges hooked up to it, ran great till oil gets hot, Left side shows round 300 psi area an oil pump supply line would show nearly the same, right side would show maybe 320 area an supply line would be nearly same too...
  8. C

    Kw t300 cat 3126e

    Hey guys my service trucks been giving me fits, 1998 t300 kw. Cat 3126e. Getting no codes ,cranks an runs, somedays does great on 45 miles to work, an outta no were it would start to spit an studder an then slowly flutter out dead, sometimes I can let outta the throttle and it mite catch back...
  9. C

    D57s want steer

    Hello again, finally got back out to the loader, got some of my issues addressed, got it good an hot today an it started acted up again like before , at times I can step on the right pedal an it’ll stop pulling on both sides, I can press the left side barely an it’ll go back to pulling. Kinda...
  10. C

    D57s want steer

    Hello Mr James. Do you mind sending me Ur copy of the manual if it’s on a pdf file on ur computer. Or some information on trouble shooting the clutch baskets a control valve for steering. Backwoodstractor@hotmail.com. I’ve got a mid range serial. 200100 area
  11. C

    Slow steering one side

    Yes sir I did look over ur diagram, looks just like same as the 57s. A when I had the rear basket assembly out I did take the right side apart an looked over the discs a plates. All looked good , no scoring or scratch’s, An it says 9 on the new discs. An 4.3 on the need to replace the...
  12. C

    Case Engine A-336-BD

    Hello, was looking threw here a saw were you had a pdf file for the case 336b motor. Looking for a lil help on the timeing of the counter balance shafts on the engine oil pump. Oil pump gears are timed to the crankshaft. I’ve got a parts book but no service. My email is...
  13. C

    D57s want steer

    Helping a friend look at his loader , had been working operation is fine till after a hr or so then the right side would start turning around slow on that side, also can hear a lite chatter or growling coming from right side , Figured that the right side discs were shot, so we removed both...
  14. C

    Slow steering one side

    Thx for the advice, didn’t know it has it own separate steering fluid reservoir. Figured it used same From trains or from bevel gear compartment
  15. C

    Slow steering one side

    Helping my neighbor out with his komatsu D57E -1 serial number is 20163. After opperateing 45 min or so it seems to have right side slow steering. Can mash the left pedal down to the floor an can feel chattering or growling in the pedal when it starts to steer , while driveing it tracks...
See more
Top