• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by CARLOS CABRERA

  1. C

    caterpillar d5g ecm is deprogrammed

    OK, thanks a lot.. I tell you that today I calibrated the recoil pump solenoid and turned the engine off and on several times and it did not deprogram, working normally
  2. C

    caterpillar d5g ecm is deprogrammed

    hello good morning my friend I have the photos that you had requested and the status report. please help me by checking, thanks
  3. C

    caterpillar d5g ecm is deprogrammed

    ok my friend thank you very much, I am going to carry out the procedure that you indicate to pass on the information and in this way please continue to help me
  4. C

    caterpillar d5g ecm is deprogrammed

    it will be a problem of the ecm, wiring, or some sensor the fault that is giving
  5. C

    caterpillar d5g ecm is deprogrammed

    ok tomorrow they will lend me et again to take the photo you need maybe you need some other photo to take since they lend it to me just for a moment
  6. C

    caterpillar d5g ecm is deprogrammed

    At the moment the machine is in the field and I am far from the machine but this photo is from before I tell you that I already changed the speed sensor and it remains the same also the hourmeter of the ecm changes every time the machine is turned off
  7. C

    caterpillar d5g ecm is deprogrammed

    Thank you very much for the help. I'll tell you to calibrate everything. throttle, advance solenoid reverse solenoid joctick brake pedal The machine works perfectly until it is turned off.
  8. C

    caterpillar d5g ecm is deprogrammed

    I have a 2003 Cat D5Glgp that has a right lane lock issue, only when backing up. I looked in the forum and I did not find a solution, it gives me the ET and it gives me these error codes, the post calibration is done and works perfectly until the problem is turned off and on again. and the...
See more
Top