• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by bsamot69

  1. B

    WAUKESHA VRD 155 FIND TDC #1

    I'm not sure this is the correct forum. I have a Waukesha VRD 155 diesel engine powering an air compressor on a trailer. It is used in the water well drilling process. I'm having the injection pump rebuilt, it has many problems. I was under the gun to get the injection pump to the...
  2. B

    CAT 480F IT backhoe no start

    I made a mistake on the model...it is a 420f. My bad.
  3. B

    CAT 480F IT backhoe no start

    Our CAT 480f backhoe will not start. It cranks. The machine has been operating pretty flawlessly since I replace the transfer pump some months ago. One morning I tried to start it and the battery was dead. I removed battery and recharged it. Now, it will crank but not start. When the key...
  4. B

    Case 850g dozer belt diagram

    The serpentine belt on the case 850 g broke and can not locate a diagram for belt routing. I have the CASE Service MANUAL and it does not have a diagram...anybody have access to the diagram for serpentine belt routing. No AC on this machine.
  5. B

    CASE 850G filter, hydraulic location

    Thanks for the help, pretty much a piece of cake. I keep forgetting to think outside the box with these machines.
  6. B

    CASE 850G filter, hydraulic location

    This case 850 g dozer and it's elusive filter locations...I have a case 850 g and I have the hydraulic filter cartridge that I need to find the place on machine to put it. It is probably right in front of my face but I am looking too hard for it. Pulled the covers around tank off but still no...
  7. B

    CASE 850G right track intermittent

    Our Case 850 g right track had stopped moving backwards or forward with the left track functioning as expected. I got underneath and there was a leaking line that comes out of back of trans and runs up to the controller up under the battery. There was another line off this connection but I...
  8. B

    CAT 299C TRACK tensioner help

    THANK YOU ALL for the help. The machine is back together with your help. Thanks again!
  9. B

    CAT 299C TRACK tensioner help

    I apologize, I was in excitable mode... JSP 00243 is number
  10. B

    CAT 299C TRACK tensioner help

    Our 299c track tensioner is leaking grease. Figured pull it apart to install new seal, like our other equipment. This assembly has a second seal on an inner tube that is backside of a block in the tube. Does anybody have a diagram of this tensioner? Do we need to pull out the rest of...
  11. B

    CAT 299C CAB shock help

    So, the cab does raise higher, enough to fit shock in? That's great news. I'll have more wheaties this morning and make it so. Thank you
  12. B

    CAT 299C CAB shock help

    Good morning, one of the cab lift supports on our CAT 299C skid steer came off, pin broke, and I need some ideas to collapse the shock to get it back on. Or any other ideas. That is one buff shock. Thank you in advance.
  13. B

    CAT 320D excavator fuel separator full

    Our CAT 320D excavator displays fuel separator full message after startup. Did try draining but message persists. Last year this problem occurred, the machine had a hard time just idling. Replaced some collapsed fuel hoses and a cracked banjo fitting at fuel controller. Now, the machine can...
  14. B

    CAT 420 F fuel hose routing diagram

    That's it! Thank you. A picture is worth a thousand words and in this case saved time.
  15. B

    CAT 420 F fuel hose routing diagram

    Oh damn, my bad. JWJ01898. There is a pair of fuel lines that run to the front and disappear under the radiators. That is the area of leak.
Top