• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by BlackSmokeandMetal

  1. B

    John Deere 2154D (hitachi -3 zx250 size with Deere engine) stalling engine when operating hydraulics at low rpm.

    Hello again, thank you all for your help so far. i was at this machine and attempted to measure the PWM signal to the torque control solenoid backprobing it with frequency measurement on my multimeter. unfortunately this problem has now turned 180Deg and my pumps are now stuck at minimum...
  2. B

    John Deere 2154D (hitachi -3 zx250 size with Deere engine) stalling engine when operating hydraulics at low rpm.

    Thank you for this. Yes the monitor displayed is correct. I am not sure what Hitachi it crosses to but chose ZX250 as some parts cross over. I have checked for any faults through monitor and there is none present. I thought i checked the regulators correctly by checking minimum and maximum pump...
  3. B

    John Deere 2154D (hitachi -3 zx250 size with Deere engine) stalling engine when operating hydraulics at low rpm.

    Thank you all for the replys so far. 1FF2154DTB0210319 is the serial. At high RPM the engine is still pulled down a little more than it should but not to stall point. I have Service advisor and have run several engine tests viewing all the ECU parameters (the only controller i can see through...
  4. B

    John Deere 2154D (hitachi -3 zx250 size with Deere engine) stalling engine when operating hydraulics at low rpm.

    Hello all, as above when operating this machine at low idle rpm like a warm up scenario, if anything more than 1/4 or half movement of the joystick booming up or arm out it will pull the engine down and if not feathering the controls back toward neutral it will stall the engine. i have diagnosed...
  5. B

    Hitachi ZX 160 LC Year 2003 bogs down, looses power and stalls

    I have a similar problem on John Deere 2154D. At idle rpm working boom or arm will pull down engine to stall. I suspect an MCX controller issue as I have tested voltage at torque control solenoid when functioning machine and pulling engine rpm down and there is constant 24v. I i disconnect...
  6. B

    Hitachi DR.EX cable work with MPDr?

    Did anyone have a circuit diagram for the cable? I previously used the MPdr cable from Deere and it was simply the 6 pin hitachi connector - 9 pin com and then com- usb. I have purchase the required connections and cables but need to know the pinout to assemble the 6 pin to com cable??
See more
Top