• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by bad Tom

  1. bad Tom

    Case 440 self leveling problems

    The left switch is for turn signals if used, if the top switch has just 2 positions, then it is a on or off for constant flow with pressure from the male coupler. If the bottom switch has 3 positions, pushing on the left side will pressurize the female coupler and pushing to the right side will...
  2. bad Tom

    Case 440 self leveling problems

    Left handle controls the hydraulic functions on the front of the boom. The right handle controls the functions of the front electric connecter.
  3. bad Tom

    Case 440 self leveling problems

    KSSS is correct about the operation. I field installed the self leveling on my 420 and it didn't take much time to learn how to use it.
  4. bad Tom

    Service Manual

    I bought all of mine from ebay.
  5. bad Tom

    2008 Case 440CT-3 Skid Steer good or bad?

    My early 440CT has C block tracks and I can spin them at a dead idle. It really does not need 89 horse power but I like having it.
  6. bad Tom

    1845c external hydraulics

    I have no specs for the 1845C but the 1835C has a flow of 16.4 GPM and a pressure of 2250 PSI. You can rum any standard flow machine. You would have to run your engine faster than the newer machines to get the same result. Forget the high flow, that would take a lot of time and money.
  7. bad Tom

    1845 to 1845c parts compatibility.

    1979 year
  8. bad Tom

    Running a low flow brush cutter on a high flow machine

    I don't think you could do any damage to the loader running it at that rpm. I don't run my loaders wide open now.
  9. bad Tom

    1845C, needle bearings in drive chain box

    How about slacking off the drive chains and then try to shake the drive gear with a pry bar and see if it's got play in it. I would do that first and go from there.
  10. bad Tom

    Running a low flow brush cutter on a high flow machine

    The only way to know how much flow you have is connect to a flow meter and check it at different engine speeds. The brush cutter I have is for 15 to 25 GPM. The hydraulic motor is only 20 GPM max. I am running more gallons a minute more than it can handle and I had to replace the control valve...
  11. bad Tom

    HTO fluid solution?

    You can go to any ag CaseIH dealer Like KanEquip in Topeka or a dealer in Smithville.
  12. bad Tom

    Case 90XT

    It's called a "filter head" and the part number is 87439984. Hopes this helps.
  13. bad Tom

    HTO fluid solution?

    I have mixed and matched different oils over the years and had no problems. The 10 wt oil is rated for temps between -10 and 70°, where the 10w30 will work past 112°. I don't see any problems going to rotella,
  14. bad Tom

    Case 1840 was cranking over now just clicks

    Take the pin out of each boom cylinder and use a chain hoist or loader and raise the boom and lock it up, then slide the cab forward to get to the starter.
  15. bad Tom

    Case 1840 was cranking over now just clicks

    I would start looking at the battery cables. They can look good but melt the solder on the inside at the terminals. Another area is the connection at the starter where the cable connects. They can come loose or need cleaning.
See more
Top