• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Alan Caro

  1. A

    CAT 314E LCR all Hydraulic functions stopped working while moving

    I was working on a CAT314E LCR moving some debris around and all of a sudden it stopped doing all functions, none of the joysticks do anything, it does not track and the blade that is installed won't move up or down. The machine turns on just fine and seems to be in normal condition We checked...
  2. A

    CAT 314E 2014 Problems turning left and right all other functions working properly

    I was using the excavator today and it simply stopped doing every function, won’t track swing, nothing. Any ideas on what it can be?
  3. A

    S130 Traction lock won’t work on slopes

    I have a 2014 Bobcat skid-steer and the traction lock won’t stay put (skips over disk) whenever its on a slope, eventually it engages when its on level ground. I checked the block and it has minimal wear to it, I checked the disk that the block is supposed to stop with and it did show some sign...
  4. A

    John Deere 550-C Year

    I have a JD 550-C that I’m trying to fetch the year from serial number 550-C 335027T
  5. A

    CAT 314E 2014 Problems turning left and right all other functions working properly

    I was able to get some time to check the excavator, I found the solenoids in the picture, the cables seemed to be ok but did not test them, I went ahead and swapped them out (the track and the swing solenoid) and put everything back together and it started working properly, I have yet to test...
  6. A

    650H won’t start

    Thanks for the help!
  7. A

    650H won’t start

    Hello! Had some time to work on it, I checked the wiring with the power probe and noticed that there were 12V going into the starter relay and 9.0V going out of it, decided to go ahead and replace it and it has worked properly since then, might have been lucky there.
  8. A

    CAT 314E 2014 Problems turning left and right all other functions working properly

    I have this CAT 314 that will not turn left or right, I’m not sure if it’s electrical or mechanical, you can sometimes get it to work after playing with it for a long time, other times you can turn it off and on and it seems to start working again, until them it randomly gets stuck, I can hear...
  9. A

    650H won’t start

    Ok hopefully tomorrow if I have the chance I will check those, is there a possibility for it to be the thermostat sensor too? I saw that on some john deere tractors the thermostat sensor gets bad and it does the same thing
  10. A

    650H won’t start

    More info: The problem begun slowly as it became more progressive, sometimes after a few tries it would start and continue to start other times we jump started it and it would start and continue to start without the jump starter in normal condition we checked the battery connections twice and...
  11. A

    650H won’t start

    I have a 2004 650H that when you try to start it, it seems to cut power to the system, I checked if the powershutoff was the problem by jumping both negative cables on the same side and it stayed the same I also checked the negative cable for conductivity and it seemed to be working fine any...
  12. A

    600AJ malfunction code on crank

    Thanks! I verified, seemed like something was eating up all the voltage when I tried to start the engine, started checking everything and the starter was fine, computer was swapped and it stayed the same, checked the cable the sends the signal and it was fine as well, I decided to disconnect...
  13. A

    600AJ malfunction code on crank

    Having problems starting a 600AJ Boomlift, anyone can help me what this code means?
Top