I'm looking for a hydraulic winch that could hold 3500-4000' of 3/8" line.If you are needing parts, the guys at winchesinc. sourced me some parts for a ancient tulsa winch I have. I dealt with the guys from the Broken Arrow branch.
https://winchesinc.com/about-us/
I'm looking for a hydraulic winch that could hold 3500-4000' of 3/8" line.
Know of any?
That rig is a Tensioner for conductors on a power line, wire goes thru this and it holds back so the wire don't sag to the ground while it's being strung.could this be modified, it's cheap enough.
1986 Ford LT800 Reel Truck - 3208 Cat Turbo Diesel Engine - Allison Automatic Transmission - 43,000 actually miles - All Steel Flatbed - Tandem Rear Axles - PTO with front hydraulic winch - Starts, Runs, and Drives Excellent - Reel Unit is a 52 inch bull wheel tensioner with 6 cylinder gas industrial engine - Gas engine also has on-board compressor - Reel Unit shows 890 hours - Runs great - Air brakes with air to the rear and pintle hitch - This is a very low mileage/hour Unit that is very clean - Reel Unit could easily be removed for a great Flatbed Truck - Ready to work - Priced to sell at $10,500 - Located in Boulder Mt - Cross Posted
Take a pretty big drum for that much, I don't know of anything right now for sale.
What happened to your international with the drum set up?
Didn't see one I was just explaining how a tensioner is used.Where is the puller listed?
Ahh, good explanation though!Didn't see one I was just explaining how a tensioner is used.
Bad Bob
I'm looking for a hydraulic winch that could hold 3500-4000' of 3/8" line.