Your dozer photos

[djordje1]

 

[Willie B]

My cylinder spacing is 2" narrower than the space between shoes. Overall width is something like 5' 10". Dresser specifies 15" standard shoes, 17" offset shoes, or wide track models with 24" shoes, but the frame is very different. That 1/2" lost because of wider shoes, is needed. I'm afraid I'll end up cutting the shoes to get clearance.

Willie

 

[56wrench]

My old D8 46a. One of the last low-horse models. 1965 vintage

 

[gtermini]

View attachment 166864 View attachment 166864

That thing sure looks a lot like an old flat track D5. D5D clone?

Greyson

 

[Steve vic]

my Allis 11B

 

[Metalman 55]

View attachment 167127 my Allis 11B

Nice old 11B! What year would that be.....about a 72? I ran one like it back in the early 70's except with the 13' angle blade on it. It was a nice machine to run.

 

[Steve vic]

Hi Metalman its a 1973 model , i have both straight and angle blades for it as well as 12' stick rake yes is a very smooth machine to operate is pretty quick compared to my EP and plenty of power while very good on fuel

 

[farmerlund]

Do the ripper shanks Pivot on the main bar? I don't think I have seen one like that before. There are hardly any Allis machines around my area. looks like a nice tractor.

 

[GManBart]

My little D3B....has the wrong stickers on it.

 

[Honcho]

Hello from Russia

 

[Metalman 55]

Hi Metalman its a 1973 model , i have both straight and angle blades for it as well as 12' stick rake yes is a very smooth machine to operate is pretty quick compared to my EP and plenty of power while very good on fuel

I'll see if I can find a picture of the 11B that I ran & post it one day soon!

 

[BLADEMADE]

View attachment 166581 74 Td 25 c trying to survive in a cat world[/QUOT
I'll take that over a cat any day of the week

 

[Willie B]

7G

TD7G in fresh paint. It has had its baptism since the picture was taken. The blade in no longer yellow.

 

[bwmwaima]

 

[Wes(MI)]

My 1956 D4 7U, with Hyster D4E winch.

 

[Tinkerer]

Awesome looking TD7 Wille ! I hope the tracks loosened up after you ran it.

 

[Willie B]

Awesome looking TD7 Wille ! I hope the tracks loosened up after you ran it.

I loosened them up before using it.

 

[gary808]

Our d9h, pulling steering clutches and bevel gear shaft.

 

[gary808]

Our d7e being used to stand a 6" power pole.

 

[Crook_Donk]

Reborn D9H going back into full service in Western Australia.