sadegs
Active Member
I recently picked up a skat trak 1350, with the kubuta engine. runs great, but hadn't been touched in years.
the bottom was caked with leaves and oil. I powerwashed it out, along with a few other areas that needed to worked on.
it started right up after spray down, but after a minute or so, I could hear it running rough, like not all cylinders were firing.
I shut it off, and it is sitting in the sun to dry out.
I was careful not to spray near the intake, but I did notice a small hole in the exhaust, very close to where the 4 manifold pipes become 1 pipe. I hadn't sprayed directly into the hole, but some water may have gotten in there.
any suggestions how to clear the water?
the bottom was caked with leaves and oil. I powerwashed it out, along with a few other areas that needed to worked on.
it started right up after spray down, but after a minute or so, I could hear it running rough, like not all cylinders were firing.
I shut it off, and it is sitting in the sun to dry out.
I was careful not to spray near the intake, but I did notice a small hole in the exhaust, very close to where the 4 manifold pipes become 1 pipe. I hadn't sprayed directly into the hole, but some water may have gotten in there.
any suggestions how to clear the water?