chrisragsdale
Member
- Joined
- Jun 27, 2016
- Messages
- 6
- Location
- Victoria Tx
- Occupation
- Owner of Southbound RV Park and Crossroads Septic
Hey I just bought a Cat CS-433C vibratory roller. The drum was swapped for a padfoot at some point in case that's relevant info.
I'm going through the manual and I see the hubs drum etc call for 75wt oil. Could I just use 80-90 in it? It seems reasonable and I'm in South Texas it never freezes here.
Your thoughts?
Other things to check for on these machines?
I'm going through the manual and I see the hubs drum etc call for 75wt oil. Could I just use 80-90 in it? It seems reasonable and I'm in South Texas it never freezes here.
Your thoughts?
Other things to check for on these machines?