Part Number for CAT

[JGS Parts]

Anyone know the part number for a D10N cutting blade for on a semi U blade and the same for a D11R?

thanks

[Nige]

You mean a cutting edge I assume ..? Normal edge or ARM protected..? Standard or extra thick for more wear material..?

[Nige]

As usual it's not simple ..... depends on the Serial Number prefix of the blade - located on a plate on the back side of the blade at the RH upper corner. Doesn't matter if the tractor is an N, R, or T, they all use the same type of blade so cutting edges will fit pretty much anything so long as they suit the Serial # prefix of the blade.

10SU blade .... 79W-prefix

In each case the first Part Number is installed in the centre of the blade, the 2nd one on the outside before the end bits.

35mm thick edges - 2 x 1U-4499 & 2 x 1U-4455
40mm thick edges - 2 x 4T-0081 & 2 x 4T-0082
45mm thick edges - 2 x 6Y-0016 & 2 x 6Y-0017
50mm thick edges - 2 x 4T-0607 & 2 x 4T-0604
60mm thick edges - 2 x 6Y-0020 & 2 x 6Y-0021

All other 10SU blades - 1RH, 7RH, 4KP, 6EP, BHJ, BHA

35mm thick edges - 2 x 9W-6609 & 2 x 9W-6608
45mm thick edges - 2 x 9W-6656 & 2 x 9W-6657
60mm thick ARM-protected edges - 1 x 195-9170, 2 x 195-9171, 1 x 201-1230

11SU blade - all prefixes

45mm thick edges - 2 x 9W-2426 & 2 x 9W-2425
60mm thick edges - 2 x 9W-4495 & 2 x 9W-4494
75mm thick edges - 2 x 135-9577 & 2 x 135-9578