• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. Russelln

    Injector pump gasket

    Be Smart and do exactly what thepumpguysc says, I'll add to it to make damn sure that all areas are extremely clean and you might as well get the rubber O-Rings that go in the throttle shaft and fuel shut off shaft because they will leak next. You can get those gaskets and 4 rubber O-rings as a kit.
  2. Russelln

    Case brake cylinder rebuild

    Try Brokentractor dot com, what you don't see on there web page you can get by calling them.
  3. Russelln

    Where on a Case 580SE can you attach chain to pull things?

    I got to admire what you have done there.. So let me share my thoughts with you since I been down this road before. I too have a Case 580SE and you might be able to get away with looping that thing around the backhoe bucket and driving forward with it, if you have the extendahoe, that might help...
  4. Russelln

    580E nasty vibration

    No, You would know by just grabbing the fan and moving it side to side. You could remove the belt though and see if the bearing is shot in that tensioner. Those go bad as well.
  5. Russelln

    Ford 555 engine that was run without oil.

    I would walk away from it. Sounds like this unit has never been maintained and judging by the oil incident backs that up. I think it would cost you as much to repair that unit as it would to buy a decent used unit.
  6. Russelln

    Ford 555 engine that was run without oil.

    I think the information Phil gave you pretty much covers it.
  7. Russelln

    580sk wiring question

    perhaps, sounds like something got moisture in it and dried out and got resistive. I would disconnect the negative battery terminal and check plus clean all the connections. If you have a service manual with a schematic in it that would narrow it down to which harnesse(s) would be effected. Also...
  8. Russelln

    580E nasty vibration

    I just had this problem with my 580SE. Mine ended up being that bearing that is in the pilot shaft that holds the fan blade on. Just grab the fan and see if it moves from side to side. If so that part ran me $230.
  9. Russelln

    JCB won't move!

    Yep, Always carry a can of WD-40 for that problem.
  10. Russelln

    580 Super E - Headlights spike Temperature!?

    You know, I would like to help you out, but when someone like the last owner goes in there and modifies things and makes a big mess, explaining what to do could make manners worse. Do you have a service manual with the electrical schematics? My only help to you would be for you to PM me...
  11. Russelln

    Case 580se Starting problem

    Oh how I remember this Problem, Been there done that. I even added a Ford Solenoid to mine before I preformed the real fix. With two people and a volt meter (VOM) Measure the solenoid wire at the starter with your helper. If the voltage drops below 10 volts you got problems. If you...
  12. Russelln

    Cheap backhoes

    Every single part for the Jinma is available here in the USA. There are a couple of places that stock everything for every size Jinma. With that being said, I’ll take my lumps like a man for buying one of these in 2006. As I was just starting out on my Almond farm and I needed something quick...
  13. Russelln

    580B shuttle dip stick

    I agree, Next time you replace the fluids, leave it a couple of quarts low and mark the stick and then fill it to manufactures specs and mark the stick. I would make those marks with a die grinder on a dremal tool so that they will always be there. Awesome looking machine..
  14. Russelln

    $$ For Knowledge

    You can click on the users name and send him a private message that is only viewable between the two of you.
  15. Russelln

    Case 580B CK

    Case 580B CK Backhoe; Length:22 ft. Width:8 ft. Height:10 ft. Weight:12500 lbs. ...
  16. Russelln

    Driving on the road?

    Some backhoes are AG here in California because we need them to dig out stumps for Walnuts, Almonds, Cherries and wine grapes for replants and Also Irrigation. But no one in my area has ever questioned it.
  17. Russelln

    Driving on the road?

    Just like i told you, Do what he says and get that plackard and enjoy.
  18. Russelln

    Driving on the road?

    It is recognized, You must have it mounted in the rear and very visable.
  19. Russelln

    Driving on the road?

    Welcome to California. First, Go to your Local Tractor supply or equivalent and pick you up on of those slow moving vehicle triangles. And mount it on the back of your tractor where is will be very viewable. Go to the State DMV dot gov and in the vehicle codes look up “Implements of...
  20. Russelln

    Looking at Case 580e

    The only issue that I know of with the 580E or SE is Electrical and the fix is super simple. Helped repair about 30 of them in my area here. There is a 8-Pin connector that runs from the main harness from the dash to the Starter solenoid and the alternator and the main 12 volts going up there...
Top