• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Search results

  1. Dave Neubert

    #3406C low power

    Was working fine then as I was told it started bogging it runs a air compressor should build 350 psi starts bogging at 200 psi with very little smoke timing good governor seems to respond
  2. Dave Neubert

    #3406C low power

    It has a oil pressure advance
  3. Dave Neubert

    #3406C low power

    yes the specs I got from Cat said 18 psi the one you got is higher
  4. Dave Neubert

    #3406C low power

    No I put the correct block off plate on the pump. no waste gate pump was set 10% over
  5. Dave Neubert

    #3406C low power

    The performance chart calls for 18 psi unless 36.5 hg conversion was wrong
  6. Dave Neubert

    #3406C low power

    Starts good
  7. Dave Neubert

    #3406C low power

    Mechanical
  8. Dave Neubert

    #3406C low power

    both are with in specs fuel pressure 35-40 boost 18psi
  9. Dave Neubert

    #3406C low power

    3er01959 this is a high horse 525 hp in a drill rig motor bogs down under load. fuel pressure is 35- 40 psi under load, boost 15-17 psi replaced fuel lines,fuel filter, rebuilt injection pump no blow by on engine, any one have any ideas motor exhaust hardly smokes under load ,tried bi passing...
  10. Dave Neubert

    Splitting a cat 740b

    I did a Volvo with my 5,000 forklift
  11. Dave Neubert

    Old 1977 JCB 1400 Fuel issue

    Can't tell you how many calls i went to because someone put the seal in the filter and not the groove
  12. Dave Neubert

    CAT 345C Excessive vibration

    pull the case drain filter and look for Debrie
  13. Dave Neubert

    Volvo EC700B Boom lights quit

    Yes there should be a fuse or breaker. get a volt meter and trace the power to see where their is a open circuit
  14. Dave Neubert

    bobcat E 60, air condition system clicking and turning the clutch on and off

    low freon can cause this
  15. Dave Neubert

    D69U Fan Belt replacement

    I would think it would be better to and grill too
  16. Dave Neubert

    D6D LGP powershift, missing connection of air transfer tube from transmission to rear of torque converter

    Nige is correct if you don't replace the line at least put a breather of some sort on both sides there is no pressure or oil going thru it
  17. Dave Neubert

    Front driveshaft needed

    Iron peddlers has a lot of them parted out 704-289-8591
  18. Dave Neubert

    D7F Timing Injection Pump

    ok then do like TC says
  19. Dave Neubert

    D7F Timing Injection Pump

    you don't use the plate for this style. I use a drill bit in the timing hole
  20. Dave Neubert

    Building a Lake

    You need to stay away from this 955 it sounds like a money pit. I would get a d7 or d8 and a 615 pan to do what you need to do 200- 300 yards is a long way to push dirt
Top