• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by PA Track & Welding

  1. P

    Track press?

    Might get more hits if you tell people you want a pin-press, thus portable. Track press to some Implies a permanent shop tool.
  2. P

    How Did You Find Us?

    Digger242j If I try to respond to people looking for stuff, it tells I do not have privileges to respond. I have posted 6-7 times on forum but then realized I was looking at old post not new ones. Any help
  3. P

    How Did You Find Us?

    Was looking downsize undercarriage shop and unload some used equipment. Did not have much luck so wife poked around different sites and found this site. Signed up and replied to some post,but trying to figure it all so I follow all the rules. Wish I knew about this site a long time ago,really...
  4. P

    Case 450 idler and adjuster needed

    Paint Valley equipment in Ohio has track adjusters for older case machines, but may only sell to dealers worth a Google search
  5. P

    Tack welding pads to chain links?

    If bolts are 5/8, ask cat for D-4H bolts. They have a bigger shank diameter. Bigger shank hopefully fill extra space in worn holess on the pad and link. If 3/4 use D6-H track nut and bouts. Then weld.
  6. P

    450 Case tracks

    James Be careful, the width of the 450B rails are wider than straight 450 and may not fit inside the roller flanges. Measure width of both to be sure. Also straight 450 sprockets can be straight or dished but could never tell which it took by sn. Hope this helps.
  7. P

    OTC 100 Ton Track Pin Press

    HI Joel@ Nelson brothers. 37 years of tearing tracks apart is enough fun. Going to keep phone number and just sell parts and consulting without the labor. Track shop would look good in NY.
  8. P

    OTC 100 Ton Track Pin Press

    I have a 200 ton OTC twin ram track press. Fully operational with toolings from 5 3/4" pitch through 10 1/4" pitch; 32' conveyor table with ramp; WTC 3,000 ft lbs rolling electric impact gun; 3-phase power. Spare hydraulic lines, fittings, belts, switches and spare part for tracks. $14,000 for...
Top