• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by Jeff R Anderson

  1. J

    125 galion

    Thanks, engine serial number is 682 and they started building the d282 in like 57, can't locate the machine serial number because the tag is gone and the one that should be on the frame had something welded over it at on time and has rusted away, it has a cab serial number and it's 800...
  2. J

    125 galion

    So I have gone around 5 times looking in the top holes, cleaning any debris off so I didn't miss it, I have gone through the open hole that exposes the driven gear teeth and and looked between every tooth several times and used a probe and I can't find anything
  3. J

    125 galion

    Greases the driven gear, one on each side at 10 and 2
  4. J

    125 galion

    So I have two pipe thread covers, the large one gives you access to the bearing bolts, the other, much smaller, let's you see the bolts but it's not big enough to get a socket thru, this machine is old, can't find any serial numbers except for the engine, IH d282 868 serial number, so my...
  5. J

    125 galion

    I am trying to find the grease fittings to lube the turn table bearing, I was told there between the outside gear teeth, I have removed the top plugs where you access the bolts and can not find anything, nor can I locate any between the teeth thru this hole, anyone know?
  6. J

    Gallon crane

    Does anyone know where you grease the rotek bearing for the turn table, took off the pipe caps on both sides and rotated it 360⁰ and cannot find a grease fitting, the book does not show the location and the technical guy at cherry picker ( parts supplier for galion) hasn't seen one like mine...
  7. J

    Galion 125 crane, rotary valve takes 10 of #8 and one of #7 there's 10 grooves on the cylinder, where does #7 oring go?

    I believe you are correct
  8. J

    Galion 125 crane, rotary valve takes 10 of #8 and one of #7 there's 10 grooves on the cylinder, where does #7 oring go?

    I studied the drawing and I've come to the conclusion it goes on top to seal the inside diameter of the barrel and the other one goes on the top OD of the cylinder to seal debris from ingress through the top plate hole in its center
  9. J

    Galion 125 crane, rotary valve takes 10 of #8 and one of #7 there's 10 grooves on the cylinder, where does #7 oring go?

See more
Top