• Thank you for visiting HeavyEquipmentForums.com! Our objective is to provide industry professionals a place to gather to exchange questions, answers and ideas. We welcome you to register using the "Register" icon at the top of the page. We'd appreciate any help you can offer in spreading the word of our new site. The more members that join, the bigger resource for all to enjoy. Thank you!

Recent content by 12v92

  1. 1

    kubota d722e cylinder head

    if i had to guess i would say overheated
  2. 1

    kubota d722e cylinder head

    cracked
  3. 1

    kubota d722e cylinder head

    hi guys! i want to pick your brains if possible i need to replace the cylinder head on a d772e kubota engine. my question is do i stick with a factory casting or go with an aftermarket replacement casting? i have no experience with these, just wanna make the right choice. the cost...
  4. 1

    Cummins ISB no start

    i had the same problem with a isb. i removed the high pressure pump and set it on the bench. i stood there for a few minutes looking at it and figured what the hell......it's no good now what can it hurt? i removed the charge pump from the front and disassembled it. seems a piece of...
  5. 1

    3408 cat question

    THANK YOU ! as usual you are a tremendous help ! i appreciate your help!
  6. 1

    3408 cat question

    67U16903
  7. 1

    Favorite phrases you use

    i would agree with you but then we would BOTH be wrong!
  8. 1

    3408 cat question

    OK, SO 67U16XXX Will DEFINITELY have the pencil nozzles? is this what would be referred to as a ''B'' motor? thanks!
  9. 1

    3408 cat question

    hello all! was wondering if someone could tell me when they went to the pencil injector on the 3408? serial number prefix is 67U thanks!
  10. 1

    sullair 1150/350 drill compressor

    just what i was afraid of...................CRICKETS!!!
  11. 1

    sullair 1150/350 drill compressor

    hi guys! was wondering if anyone here is familiar with sullair 1150/350 drill compressors? i'm trying to find out the bearing preload and rotor to end plate clearance on the high stage? sullair wont give up any info! thanks in advance for any help
  12. 1

    John Deere 450B frozen steering clutches

    these are dry clutches. they will absorb water/oil and swell, and also will change the drag coefficient. once they are soaked with oil i'm sure you will be changing them. fill em with fuel oil and let us know how you make out. just sayin
  13. 1

    Compact overheats until the hood is opened...

    water pump operation can be checked with a pressure gauge in the system close to the output of the pump. from the pics the fan is correct. if you grab the fan blade and try to turn it, does the belt slip easily? tighten and/or replace the fan belt... thats my bet
  14. 1

    John Deere 450B frozen steering clutches

    i would definitely NOT fill the housing with kerosene or anything else. did you remove the drain plugs to see if housings were full of water? this is usually the culprit. leave the plugs out if you are not going to run it in deep water. hold the levers back and ride it around.... alot of times...
  15. 1

    3306 PC truck engine

    unfortunately, the parts book for the engine doesnt show either! anyway... thanks again to cmark for figuring this out for me!!
See more
Top