View Full Version : rumble strips
03-19-2010, 04:02 PM
Here we are rumbling just outside of Ottawa,Ontario on TCH 417 using a wirtgen 600. It was a volunteer job as we are out of Moncton,New Brunswick
This link will take you my youtube channel where i have more vids of grinders and pulverizers.
03-19-2010, 04:10 PM
:eek:"volunteer job" i wouldn't volunteer to run that contraption if ya paid me to:Banghead
03-19-2010, 07:35 PM
Bet that operator jerks all night in his sleep....bah ha ha
03-19-2010, 08:16 PM
is that an operators job, or a bull riders training kinda thing?
03-19-2010, 08:47 PM
LoL, I used to operate an old Allis Chalmers HD-6 with stuck track links that didn't bounce that bad. Bounciest thing I believe I've ever seen. :D
03-19-2010, 09:01 PM
:eek: When I spend 10 hours on a boat deep sea fishing, I rock back and forth for a few hours after. I couldn't image what that would feel like at the end of the day. Although it would run smoother with a round wheel on the front right...:D
03-19-2010, 10:16 PM
That looks like the worst thing ever! Looks more like punishment than anything! Sum engineers were really thinking when they came up with that contraption!
03-20-2010, 11:18 PM
Miller have one in Atlanta too. I rumbled quite a bit with it. Hard to hold straight when that front tire is worn down.
Actually, the up and down motion put me to sleep almost...
03-21-2010, 02:45 PM
:bouncegri :throwup :bouncegri :throwup :bouncegri :throwup :bouncegri :throwup :bouncegri :throwup
Ive heard of people at rotomill who have had major health problems from running those damn things.
05-04-2011, 10:28 PM
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.