Compact 1 YD Scraper

[Northart]

Compact 1YD Scraper pulled behind a 30-50 hp farm tractor with 3 pt . Also a pull behind grader .

Just some of the neat compact equipment this Mfg. offers .


http://www.hoelscherinc.com/prod_dbscraper.htm

[bobcat ron]

Awwww, now the little boys can play along side the big boys now!!


But they do have some neat toys though.

[atgreene]

I can't see that tow behind blade staying behind the machine when angled. I suppose as long as you want it to ride out it would be ok, but a hard cramp angle and it seems like it would slide easy. My 8' 3 pth woods blade will pull my 6500 lb tractor sideways when pulling hard.

BTW, that lower link gooseneck style hitch set-up is sweet!

[bear]

I can't see that tow behind blade staying behind the machine when angled. I suppose as long as you want it to ride out it would be ok, but a hard cramp angle and it seems like it would slide easy.

I totally agree with you there. maybe a little weight in the rear? I doubt much could be done with it without some added poundage but I'd like to test one on some of my farm trails. As little snow as we get here as it is it would probably be about perfect.

Any one ever tested one?

[Taylortractornu]

I built a pull blade for a tractor like that one time using the steer axle off a Massey combine. I left the cyliner on ut and then mounted the frame on the axle pivot. with another cylinder. That gave me a tilt and the blade andgle was also hydraulic. When I wanted to angle the blade I would turn the axle into the cut like a tilt on a grader. worked pretty good I sold it to a farm not too far from here, we mounted a counterweight off a lift truck on it and that helped alot.